Rev.A
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
LOWERUPPER PLATEREAR PLATE
SHELF DECK
BRACKET
SIDE
SUPPORT
Fig 1 - Upper Plates Assembly Fig 2 - Upper Plate Placement
7160-0438
INSTALLATION INSTRUCTIONS
Form Product Revision
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Printing Spec:
PS-001
Description
6. Set the plates into the factory holes in the parcel shelf (Fig. 2). Drivers side shown.
1. Remove rear seat cushion and back rest
2. Remove C pillar trim panel from both sides of vehicle
3. Remove the parcel shelf carpet/board
4. Remove factory installed trunk shelf is so equipped. Factory trunk shelf is attached with 5 nuts
accessible from between the rear windshield and parcel shelf.
5. Screw three (3) ¼-20x3/4 bolts into each of the Upper Plates as shown (Fig. 1). Note plates are
the same however installing the bolts creates a left hand and right hand Upper Plate.1.
INST-575
NGPI SEDAN TRUNK SHELF, 2012+
© copyright 2011 Gamber-Johnson, LLC
(9 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals