Gamber-johnson 7160-0062 User Manual download pdf

Toyota Tundra Vehicle Base, '07 and Newer

INSTALLATION INSTRUCTIONS

Product Date Form #

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

7160-0062

08/01/07

INST-342

•You must read and follow all of these installation instructions. Failure to follow the

installation instructions may result in serious bodily injury or death.

•Do not install or use the Toyota Tundra Vehicle Base in the area in which the airbag in the

vehicle may be deployed. The installer and user of the Toyota Tundra Vehicle Base are

responsible for installing and using the Toyota Tundra Vehicle Base outside the area in

which an airbag may be deployed. (See Product Mounting Disclaimer Below)

•Keep these installation instructions with the product and readily available in the vehicle

for future reference of other users of the product.

•Additional copies of the installation instructions can be obtained from Gamber-Johnson.

If you need assistance or have any questions, call Gamber-Johnson at 1-800-456-6868.

•Do not remove warning label from product under any circumstances.

WARNING

Product Mounting Disclaimer

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

1. Begin by removing the front seat bolts of the front passenger's seat. Loosen the rear

seat bolts of the same seat.

2. Tilt the seat back enough to slide the the base under the front legs of the seat.

3. Align the cut-outs on the base under the dimple on the

seat leg. The dimples are intended to rest centered in the

cut-outs. Take note of the rectangular notch on each cut-out.

There is a small post on each seat leg that helps to align the

seat when being installed. This post is intended to insert into

the rectangular notch.

FIG. 1

Toyota Tundra Vehicle Base

Cut-out

Rectangular Notch

Sheet 1 of 2

1 2

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

Toyota Tundra Vehicle Base, '07 and NewerINSTALLATION INSTRUCTIONSProduct Date Form #If you need assistance or have questions, call Gamber-Johnso

Page 2 - Sheet 2 of 2

WARNING•The Toyota Tundra Vehicle Base should not be positioned in the area where the airbag may bedeployed.•DO NOT position the equipment in front of

Comments to this Manuals

No comments

Gamber-johnson 7160-0062 User Manual

Browse online or download User Manual for For the car Gamber-johnson 7160-0062. Gamber-Johnson 7160-0062 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Gamber-johnson 7160-0062